Still working on the switches wirings

Now that the switch panel is in place I begin wiring them. There are some terminals to crimp, some wires to fabricate and the routings to do.

I finished wiring the D-subs on the panel. I still have to wire all the switches.



Before doing that, I drilled the holes in the subpanel for the wires from the EIS going to the terminal strip. The bigger hole on the left is for all the intercom wires.

Still working on the wiring. I wire the D-subs for the EFIS and EIS. Quite some wires to run behind the panel. This is the left EFIS connector, there are still three or four wires missing.



These are the two connectors for the EIS. The one on the left is for the CHT and EGTS. The one on the right is for all the other sensors (oil, fuel amps...)



This picture shows the wire run from the EIS through the subpanel.

Only one hour in the workshop to sort out the wiring. Next time I will install the switches and makes some more holes in the subpanel.