In fact I wanted to install the oil door, but it began to rain so it was not possible to make the cuts as I don't want to cut inside to avoid all the dust.



So I open the exhaust box that was wainting for some time now.



The initial fit goes without problems, the parts are superb and fit very well.
It will get more complicated with the exhaust pipes, the mufflers and the heat muffs. I would like both sides to look symetrical, that both pipes are at the same angle and that the gap between the exhaust and the parts not moving (cowl and engine mount) is big enough.



This is the right side, I could get it right after some tweaking. But I have more problems on the left side, I will make some research about the minimal acceptable gap.