Today I cut and installed the baffle seals. First I copied the templates on the sela material. I then cut the material with a good pair of cissors.



Then the baffles are drilled and deburred. The holes are then made in the seal using the kind of tool you use to add some holes in a leather belt. And this is the result for the forward right ramp.



I then reinstall all the baffles on the engine to tweak the cuts and arrange all the overlaps.



I finish the session by cutting the forward seal between the ramps and the lower cowl, using the strip fabricated yesterday.
The reinstall of the upper cowl went surprisingly without any problem.