Some small difficulties today, but I managed to finish securing the wiring of the aft fuselage. I think nothing should move in the future.



I also begun to use a new technique to make nice harnesses. The harnesses are tied to the structure using plastic tiewraps, but they are made using lacing cord. It's not that difficult, less bulky and probably cheaper (see b]HERE).



I then installed some of the wire that will have to go through the main bulkhead. The picture shows the harness coming from the rear fuselage and the autopilot servo harnesses (top of the picture).



This is the left side with the NAV antenna wire.



This is the right side with the golden COM antenna wire and the autopilot roll servo harness.



There are still some wires left and the pitot tubing.