Before working on the wiring, the workshop needs some cleaning and tidying up.
I then work on the wires going through the rear fuselage. The magnetometer and trim wires are already installed. I have to wire the rear strobe and rear navigation light.
The wires have to go through the rear fuselage bulkheads.
These is how the wire exits the rear of the fuselage. The wire will then enter the lower rudder tip through a slot I still have to drill.



This is a view inside the rear of the fuselage, the rear being to the right. Ths wire goes through the bulkheads to the front.
The nav light will be locally grounded to one of the vertical stab mounting bolts.



And a view from the cockpit side. All the wires have now to be tied down.