Not much progress today as I made a few cardboard templates for the fuse block panel. The fuses won't be reachable in flight but shoud be easy to reach on the ground.
The support will be hinged under the right side of the panel.
Before beginning, I install some parts that might cause some interference : the cigarette lighter plug, the alternate air control, a switch and the fresh air tubing shown in the picture.



I then did some test templates with the four fuses blocks and the diode.
This is not satisfactory as the lower block will interfere with the panel.



This is the final result with the support hinged to the lower part of a U channel in the back. The upper part of the U channel will be riveted to the subpanel.



This is a picture in situ, taken from the right seat. The support panel hinges down in front of the right rudder pedals.