The mixture cable has been installed on the injection body. I had to add a washer to widen the gap between the bearing and the lever.
I have to check the bolt orientation, I've read something on VAF about that.



This is how the cable goes through the firewall. I found a small problem as I had drilled the ball for the Vans cable, but the one I have to use has no protective sleeving so the diameter is a bit smaller. For the time being I just wrapped it in some tape, I will arrange this at final installetion.



I then installed the blast tubes. This is the one for the fuel pump, secured with a cotter pin.



This is on the engine side, the one with the cotter pin, for the fuel pump and the other one for the left magneto.