Before installing the baffles for good, I finish the firewall pass-throughs. This is the right side.



I then begin the installation of all the baffle screws. Some are quite difficult to install, for example this one behind the oil filler neck. After some tries, I decided to remove the oil filler neck.



And here the screw is installed.
I will have to redo the safety wire.



Another small problem in the front with the installation of the grommet protecting the propeller governor line. Getting the line and the nut through goes not without some problems.



Then I have to remove and reinstall the oil cooler for one bolt on the left.
I also reinstall the lower connecting rods and torque all the bolts.