Today I wanted to change the mechanical fuel pump gasket, but after disassembly I noticed I had the ordered the wrong part.
So I continue to work on the probes and sensors. This is the manifold that goes on the firewall. The lower sensor is for fuel pressure and the one in the middle position for oil pressure. The upper port is not used for the time being.



I then modified a fitting with the shank of a rivet to make a restrictor for the MAP line. The shank is epoxied into the fitting and drilled to 0,040". This will avoid the MAP fluctuating to much and also avoid the cylinder running to lean should there be a problem with the line.







I also begun to look at how all the cables, hoses and tubings forward of the firewall will get tidied up.