The session begins with the bending of the tab of the vertical side that will later be riveted to the inlet ramp. No problems here except for the blurred picture.



Then I have to fabricate two small conical gussets for the exterior corners of the inlets; I begin by making a paper template.



And the result after almost one hour, the template was not very accurate and getting the shape is not very easy.



And the part for the other inlet, fabricated in a bit less time.



Then I installed the forward certical baffles and the small angles. The picture shows the problem I then discovered. There is a gap between the baffle and the cowl (in front of the small angle). To get the baffle in position I had to fabricate new angles on both sides.