Before hanging the engines, I decide to install all the baffles parts that can be done without the cowl.
The picture shows all the parts I could install. Quite a lot of tweaking had to be done, mostly around the rocker covers.



This is a viaw from the rear left. The oil cooler will be installed there, but it's final position can only be known after the cowl has been installed.



This is the front right with the oil line for the propeller governor (the grommet is missing).



This is the aft baffle support bracket. To install it I had to remove two bolts on the engine case and one end of the right rear cylinder fule injection line.
The small bracket that hold the fuel line clamp can not go back to it's position on the crankcase bolt as the bolt would be to short. I will bolt it to the baffle support bracket.
I also begun to deburr all the parts that won't have to be touched again.