I finished the installation of the side latch, by making the two support angles. In four picture, how the latch works. From the outside, the two small visible parts are pinched.



This allows to pull the rear lever to unlock the rears latches.



From inside, just push the small lever.



Then pull the yellow knob. The rod that will get attached to the rod-end will open the rear latches.



I had some small work to do on the canopy jettison mechanism. But before begining, I noticed the parts were not centred correctly. Here the right pin, not fully engaged.



Here the left side. I tried a few tricks to centre everything but only managed to damage the parts, I will redo some of them.