Today I'm still assembling the canopy frame, first by clamping and drilling the two forward halves.



Then the two angles fabricated two days ago have to be installed, the plans are rather vague about the positionning. First the outside part of the frame is trimmed to allow the big angle to sit flush, then the two angles are drilled together to allow two small keeper rivets to be bucked. Those rivets are not structural.



Here the picture after the drilling with the clecos.



And now the angles have to be installed on the fuselage, on the seats bulkhead. It will be done next time as the measurment on the plan is quasi impossible to make on the fuselage.